top of page
DSCF0046-Enhanced-NR-8.jpg

VISORS!!!

VISORS

visor installation

To bend your visors to shape grab a heat gun, heat the visor for 1-3 minutes (until malleable, it should bend from the heat)

For chrome & Iridescent visors heat from the top side only, low and slow. to fast and to much heat can cause damage to the finish.

Push the visor up into place to mimic the shape of your mirrors run your fingers along pushing it into the mirror making sure it has conformed correctly. (make sure the plastic is hot if you have to force it it isn't hot enough and it may break) 

 

Hold it there until it cools down. (GLOVES OR MICROFIBRE RECOMMENDED as the plastic gets hot.)

Clean both surfaces thoroughly with an alcohol based cleaner and apply the 3M tape to the visor, then apply the visor to the mirror.

Heading 3

bottom of page